This sector involves some difficult terrain, with the Wollondilly River winding between hilly country. The eastern part of the alignment approaching Marulan is unproblematic; curves are minimal and there is even a former trackbed on the north side of the tracks that can be reutilised for most of the length.
The existing alignment out of Goulburn has a minimum radius of 600m, yet it should be possible to increase to 1000m or possibly 1500m with only small modifications to the existing corridor. Geography, other transport corridors and existing development impose substantial constraints beyond this; any faster deviation will be very expensive and should therefore be deferred until higher-speed operations are required.
North of Bungendore, the line encounters rolling countryside with a few substantial hills that must ideally be avoided. There are fewer sections of the existing alignment with minimum radius under 1000m (the smallest radius at which 200km/h is possible with tilting trains). We are therefore able to use the existing …
The final sector on the Canberra Line is the run into Goulburn, a major regional centre for which access is a priority. The existing line diverges from the Main Southern Line just south of the city, however existing radii are tight at approximately 240m. There are several options for high-speed entry …
This is what Hot Rails is all about – twenty-two kilometres of near-straight, near-flat railway corridor just begging for some trains that can really take advantage of it. We don’t need to do anything to this alignment – just upgrade and duplicate the existing track, put in some decent fences …
The line winds between hills, road and river in the picturesque Lake Bathurst valley, with the minimum radius of 800m of the first few curves unfortunately not quite meeting our requirements. Despite being wedged between highway and hillside, most of the curves do not turn through a very great angle, …
This sector follows the existing alignment through the Mulwaree River valley. While the first half is straight and uses the existing alignment exclusively, subsequently two minor deviations (albeit requiring four bridges) are required to straighten some very tight curves. Major earthworks are confined to the final few kilometres before Tarago. Alignment …
Although it is probable that rollingstock will be constructed specifically for any new HSR-capable railroads, it is far cheaper to develop a variant of an existing class of railcar than an entirely new design. This post will look at some of the existing technology that might fit our needs. The …
How do you solve a problem like Canberra Station? It’s in completely the wrong spot, and they went and built a lake and a few suburbs between the existing line and the city centre. How do we get there without resorting to a tunnel?
